If you have not had training related to common shop safety practices, you should do so to protect yourself, as well as the people around you. Tighten nut to 144 to 168 in. That's basically a brand new system that fits without any modifications to your engine or boat. Install two 2 cotter pins in upper pivot pin holes. There are four 4 holes in upper pivot pin.
Position cylinder between stern brackets. I have a 1996 40hp elo Mercury that has a manual hydraulic tilt assist on the motor to assist with the manual tilt of the motor. Any suggestions will be appreciated. Before delivering to customer, make sure outboard tilts fully up and down and turns freely from side to side. Using substandard parts could result in injury or product malfunction. Our people find our items from each of the leading shops over the internet to give you the largest selection of Tilt Assist Boat Parts together with similar accessories at the greatest prices possible.
Additional helpful information may be found in other service literature for your engine. Insert upper pivot pin from port side. Remove port stern bracket and thrust washer from tilt tube. Please research your application or ask us. Tighten nut to 40 to 45 ft.
This Mercury tilt assist unit doesn't have any damage. Make sure the spring washer is installed between the stop link and the stern bracket. Remove nut, washer, stop link screw, and spring washer from starboard side stern bracket. It is your responsibility to make sure this is the correct unit for your application. Damage to a boat and outboard can be fixed in a short period of time, but injury or death has a lasting effect.
If you are hunting for Tilt Assist Boat Parts, you have indeed come to the most appropriate place. Loosen clamp screws and fasten appropriate chain and snap hook to lifting eye on engine block. You are able to typically discover the best deals together with the very best selection. Manual is deeply indexed and searchable. This will loosen the stop link so you can access the upper pivot pin hole.
Make sure the spring washer is installed between the stop link and the stern bracket. Depending on engine model, use innermost available holes. Install two 2 bushings in cylinder. It is essential to know where this screw is located on your trim and tilt for future emergencies. Install two 2 cotter pins in upper pivot pin holes. I need to go into the plastics manufacturing business.
It may fit more than this. Tighten nut to 144 to 168 in. Depending on engine model, use innermost available holes. Before delivering to customer, make sure outboard tilts fully up and down and turns freely from side to side. Re: Manual tilt assist cylinder cable Sorry, thought I had the size right. Remove two 2 stern bracket screws and lock washers. Replace any locking fastener locknut or patch screw if its locking feature becomes weak.
You have to take the engine off boat, drill holes through transom, mount jackplate to hull, then remount engine onto jack plate. Tighten screws to 144 to 168 in. Twist and remove all spark plug leads. That is a no-brainer when it comes to working on boat motors. You still need to find a used hydraulic pump to bolt on. .
The price of this part varies tremendously over the course of a year. Also, make sure reverse thrust lock engages fully. The thrust rod must be installed in one of the other positions. It also may be used to alert against unsafe practices. I just had one small problem and I got the info I needed from this book. The newer style has a plastic nut that connects it to the cylinder. Position cylinder between stern brackets, as shown.
Install two 2 washers on upper pivot pin. It is a take-off model, new from the factory. It doesn't make much sense. I've also read that some of the older units had cables that could not be replaced and I'm wondering if I have a unit like that. Tighten nut to 14 to 16 ft. Install previously removed stop link screw, washer, and nut through stop link and stern bracket on port side.